IGE ENTERPRISES

"Certified Distributor Of - Low Cost Solar Panel Across The U.S.A And Worldwide "

SOLAR YOUR HOME AND BUSINESS   

Info@ige-enterprises.net 

1-(703) 730-77785

Specifications Panels

The specification include the embedded or attached dc-dc inverter with is physically part of the panel. The in`ut into the dc-dc inverter is 950 Watts.

The Grid-Tie Photovoltaic (PV) Power System consists of photovoltaic modules, a direct current to alternating current (DC-to-AC) power conversion device, DC wiring, DC and AC overcurrent protection, lightning protection, component mounting and mechanical support.

The System is designed for use on residential and small commercial buildings of typical construction. Photovoltaic mounting is rafter-secured for structural compliance with most local building codes. We comply with the 2002 National Electrical Code (NEC-2002), IEEE STD 929-2000-Institute of Electrical and Electronics Engineers Recommended Practices for Utility Interface of Photovoltaic (PV) Systems, UL 1741-Underwriters Laboratories Standard for Safety-Static Inverters and Charge Controllers for Use in Photovoltaic Power Systems and the ICBO 2000-International Building Code.

(1) Standard Test Conditions (STC) of 1000 Watts per square meter irradiance, air mass of 1.5, 25oC cell temperature used in lab testing and rating of photovoltaic modules. These conditions are only experienced in a laboratory setting.

(2) The actual energy output in kilowatt-hours your system will produce each month is a function of many site specific and instantaneous variables including the operating temperature of the PV modules, the amount of solar radiation reaching the modules, the roof angle, and the array orientation relative to the south (azimuth), shading effects, soiling and installation quality.

Accepting Orders Order Here Today!